Grid Gasketing
-
- 1) U MG 25 312 raised above a grid table
-
- 2) U MG 25 312 above by roughly 1/16″
-
- 3) A vacuum table with multiple vacuum zones
-
- 4) Each individual zone needs to be gasketed
-
- Perimeter gasketing seal
-
- Square gasketing replacement
In-Board Gasketing
-
- MDF fixture with CR 25 25 in board gasketing.
-
- Baltic Birch fixture with a vacuum port hole per part.
-
- HDPE fixture holding clear acrylic parts.
-
- Making a dedicated fixture for making guitar bodies
-
- XH 3150 round gasketing cord with parallel vacuum channels.
-
- Making furniture components using MDF fixture material.
-
- Baltic Birch fixture utilizing location pins
On-Board Gasketing
-
- Cutting boards on an MDF spoilboard
-
- Multiple spoilbaords being stored
-
- Quick banjo clamp
-
- Surface mounted gasketing
-
- Long narrow parts with vacuum
-
- Pizza paddle spoilboard
Cover Gasketing
-
- 1 of 3 : fixture set up
-
- 2 of 3: cover gasketing with vacuum port holes
-
- 3 of 3: Multiple parts fixture
-
- 1 of 1: HDPE fixture material holding parts and off-cuts
-
- 2 of 4: Close-up of cover gasketing material before removing vacuum pocket and tool paths
-
- 3 of 4: cover gasketing after removing vacuum pocket and tool paths
-
- 4 of 4: Making specific gaskets to match specific parts
-
- 1 of 4: Using engraving tool to cut cover gasketing material
-
- 1 of 4: Making a dedicated fixture
-
- 2 of 4: Cutting parts with SBC CR 0324 cover gasketing
-
- 3 of 4: close-up of finished gasket sheet
-
- 4 of 4: Parts being cut on custom dedicated fixture
